8
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
FIRMWARE UPDATING
8 - 35
[B] Confirmation of the updated data
After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
P.8-50 "8.4 Confirmation of the updated data"
If the exposure lamp blinks twice at the time of start-up and a “C270” error occurs, the model of
the scanner ROM updated may be incorrect.
Check the model of the scanner ROM and retry updating.
To Next Page
Loading...
