e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
8 - 44
(7) Turn the power OFF using the main power switch on the right-hand surface of the equipment and
remove the download jig.
When the number of blinks is other than “6” (which indicates that the adjustment value is “0”) at
the section “[A]Checking the hole punch position”, follow the steps of “5.1 Stopping Position
Adjustment” in the MJ-6102 Service Manual to adjust the value to the one that has been set
before the update.
(8) Install the finisher board access cover.
[C] Confirmation of the updated data
After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
P.8-50 "8.4 Confirmation of the updated data"
To Next Page
Loading...
