e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
2 - 38
Image
[Image void
correction]
4731-0 to 7, 7489
[Margin] 430, 431, 432, 433, 434-0 to 5,
435, 436, 437, 438
[Range correction] 7236, 7237, 7283, 7284, 7286,
7287, 7295, 7296, 7416, 7417,
7418, 7419, 7421, 7422, 7423,
7424, 7425, 7426, 7667, 7668,
7669, 7670, 7767, 7768, 7769,
7770, 7771, 7772, 7773, 7774,
7775, 7776, 7777, 7778, 8330,
8331, 8332, 8334, 8361, 8362,
8363, 8365
Color
registration
[Color registration
adjustment]
4719, 4720-0 to 1
Image control
[Temperature/
Humidity]
393
[Color/Black
developer]
386-0 to 3
[Contrast voltage] 330-0 to 3, 380-0 to 3, 381-0 to 3,
1815-0 to 3, 2675-0 to 3
[Performing] 394, 396
[Drum surface
potential sensor]
2780-0 to 3, 2782-0 to 13,
2787-0 to 8, 2788, 2789-0 to 3
[image quality
sensor]
388, 389, 390-0 to 3, 392
[Main charger] 385-0 to 3
[Laser power] 382-0 to 3, 383-0 to 3, 384-0 to 3
[TRC control] 2801-0 to 11
2802-0 to 11
2800-0 to 11
2803-0 to 11
Drive system
[2nd transfer motor] 4748-0 to 11
[ADU motor] 491-0 to 17, 4747-0 to 17
[3rd / 4th drawer feed
motor]
4707-0 to 17
[T-LCF motor] 4708-0 to 17
[O-LCF motor] 4762-0 to 17
[Feed/transport
motor]
489-0 to 17, 4740-0 to 17,
4741-0 to 17, 4742-0 to 17,
4743-0 to 17
[Transfer belt motor] 487-0 to 11
[Drum motor] 481-0 to 11
[Exit motor] 446-0 to 17
[Fuser belt] 485-0 to 11
[Registration motor] 483-0 to 17
[Reverse motor] 4744-0 to 17
[Bridge unit transport
motor]
4745-0 to 17, 4746-0 to 17
Classification
Adjustment Mode (05)
Given in the Service Manual
Given in the Service Manual and
Service Handbook
To Next Page
Loading...
