Toshiba e-STUDIO6520c - Page 80

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
2 - 42
Procedure 7
* When the automatic adjustment ends abnormally, an error message is
displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.
Procedure 8
* When the automatic adjustment ends abnormally, an error message is
displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR]
button.
Procedure 10
Procedure 12
Procedure 14
Procedure 15
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
(Sub code)
[CLEAR]
(Corrects value)
[START][START]
*[CANCEL] or [CLEAR]
[CANCEL]
[FAX]
[START]
(Test copy)
[ENTER]
Stores value
in RAM
Automatic
adjustment
[0][5]
[POWER]
* [CANCEL] or [CLEAR]
[Digital key]
(Code)
[START]
Automatic
adjustment
[ENTER]
or
[INTERRUPT]
Stores value
in RAM
[FAX]
[START]
(Test copy)
[POWER]
OFF/ON
(Exit)
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
(Sub code)
[START] [START][START]
[ENTER] or [INTERRUPT]
(Value unchangeable)
Value
displayed
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[CANCEL]
[Digital key]
(Key in a value)
[CLEAR]
(Corrects value)
[ENTER]
or
[INTERRUPT]
(Stores value in RAM)
[FAX]
[START]
(Test copy)
Manual
adjustment
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[START]
[Digital key]
(Sub code)
[CANCEL]
(Corrects value)
[CLEAR]
(Corrects value)
[ENTER]
or
[INTERRUPT]
[FAX]
[START]
(Test copy)
[UP] or [DOWN]
(Adjust a value)
Stores value
in RAM
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
(Forced performing)
[START] [CANCEL]
(STOP)