u-blox ZED-F9P Interface Description - Manual
Advance Information
MON-HW continued
Byte Offset Number
Format
Scaling Name Unit Description
18 U2 - agcCnt - AGC Monitor (counts SIGHI xor SIGLO, range 0
to 8191)
20 U1 - aStatus - Status of the Antenna Supervisor State Machine
(0=INIT, 1=DONTKNOW, 2=OK, 3=SHORT,
4=OPEN)
21 U1 - aPower - Current PowerStatus of Antenna (0=OFF, 1=ON,
2=DONTKNOW)
22 X1 - flags - Flags (see graphic below)
23 U1 - reserved1 - Reserved
24 X4 - usedMask - Mask of Pins that are used by the Virtual Pin
Manager
28 U1[17] - VP - Array of Pin Mappings for each of the 17
Physical Pins
45 U1 - jamInd - CW Jamming indicator, scaled (0 = no CW
jamming, 255 = strong CW jamming)
46 U1[2] - reserved2 - Reserved
48 X4 - pinIrq - Mask of Pins Value using the PIO Irq
52 X4 - pullH - Mask of Pins Value using the PIO Pull High
Resistor
56 X4 - pullL - Mask of Pins Value using the PIO Pull Low
Resistor
Bitfield flags
This graphic explains the bits of flags
Name Description
rtcCalib
RTC is calibrated
safeBoot
safeBoot mode (0 = inactive, 1 = active)
jammingState
output from Jamming/Interference Monitor (0 = unknown or feature disabled, 1 = ok - no significant jamming, 2
= warning - interference visible but fix OK, 3 = critical - interference visible and no fix)
xtalAbsent
RTC xtal has been determined to be absent.
UBX-18010854 - R04 Advance Information Page 133 of 259
To Next Page
Loading...
