u-blox ZED-F9P - 5.17 UBX-TIM Messages

u-blox ZED-F9P Interface Description - Manual
Advance Information
RXM-PMREQ continued
Byte Offset Number
Format
Scaling Name Unit Description
4 U4 - duration ms Duration of the requested task, set to zero for
infinite duration. The maximum supported time
is 12 days.
8 X4 - flags - task flags (see graphic below)
12 X4 - wakeupSources - Configure pins to wakeup the receiver. The
receiver wakes up if there is either a falling or a
rising edge on one of the configured pins (see
graphic below)
Bitfield flags
This graphic explains the bits of flags
Name Description
backup
The receiver goes into backup mode for a time period defined by duration. Provided that it is not connected to
USB
force
Force receiver backup while USB is connected. USB interface will be disabled.
Bitfield wakeupSources
This graphic explains the bits of wakeupSources
Name Description
uartrx
Wakeup the receiver if there is an edge on the UART RX pin.
extint0
Wakeup the receiver if there is an edge on the EXTINT0 pin.
extint1
Wakeup the receiver if there is an edge on the EXTINT1 pin.
spics
Wakeup the receiver if there is an edge on the SPI CS pin.
UBX-18010854 - R04 Advance Information Page 174 of 259