u-blox ZED-F9P - Page 48

u-blox ZED-F9P Interface Description - Manual
Advance Information
Message Structure
0xB5 0x62 0x06 0x09 (12) or (13)
see below
CK_A CK_B
Payload Contents:
Byte Offset Number
Format
Scaling Name Unit Description
0 X4 - clearMask - Mask for configuration to clear (see graphic
below)
4 X4 - saveMask - Mask for configuration to save (see graphic
below)
8 X4 - loadMask - Mask for configuration to load (see graphic
below)
Start of optional block
12 X1 - deviceMask - Mask which selects the memory devices for
saving and/or clearing operation
Note that if a deviceMask is not provided, the
receiver defaults the operation requested to
Battery Backed RAM (BBR) and Flash (if
available) (see graphic below)
End of optional block
Bitfield clearMask
This graphic explains the bits of clearMask
Name Description
clearAll
Clear all saved configuration from the selected non-volatile memory if any bit is set
Bitfield saveMask
This graphic explains the bits of saveMask
UBX-18010854 - R04 Advance Information Page 40 of 259