5-2 TM-500 User’s Guide
Quick Start: Running a Job D292144.8.fm
Quick Start: Running a Job
The following is an outline of the basic steps required to run a pre-programmed job. More
detailed instructions follow in the next section of this chapter.
Caution: Users should always wear protective eye wear when operat-
ing or maintaining the TM-500.
1. Setup Input and Output modules.
• Ensure the correct input, output and test modules are installed. Follow the setup
instructions in Chapter 4: Machine Setup if configuration of a newly installed
module is required.
• Load components into the Input Module and empty tape/trays into the Output
Module.
2. Power up.
• Power up the machine. Press Reset. Close all doors.
3. Activate the HMI.
• Double-click the TM-500 HMI icon on the monitor.
4. Home the motors.
• Open the System Menu and select Home Motors.
5. Select Job.
• On the HMI, select the Job Tab. Go to the File Menu and select Open, then
select the correct job.
• Reset Job Statistics.
To Next Page
