Inter.F
Specifies which interference filter is running. Zero means "none". For information on
interference filter algorithms, see 7.2.5 Interference Filter (page 178).
MinRev
Minor revision level of the RVP900 code that is currently running
IFDR Sat.Power
( P
MAX
)
Input power required to saturate the IF-Input A/D converter for the IFDR that is
currently attached
• 0: +4.5 dBm
• 1: +6.0 dBm
• 2: +8.0 dBm
PhaseSeq
Tx Phase modulation sequence. See 8.28 Configure Phase Modulation (CFGPHZ)
(page 313).
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | | | |
| Interference Filter Parameter “C1” in Hundredths of dB | Output 53
|----------------------------------------------------------------|
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | | | |
| Interference Filter Parameter “C2” in Hundredths of dB | Output 54
|----------------------------------------------------------------|
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | | | |
| Immediate Status Word #3 (Current State of Affairs) | Output 55
|-------------------------------|----------------|--------------|
Bit 0
Burst pulse timing adjustments can be made
Bit 1
Burst pulse frequency adjustments can be made
Bit 2
Burst pulse hunting is enabled
Bit 3
Burst pulse hunt is running right now
Bit 4
Last burst pulse hunt was unsuccessful
RVP900 User Guide M211322EN-J
286
To Next Page
Loading...