Vaisala RVP900 - Page 422

Char Function
16 Immediate Status 57–63
D6 = GP59, D14 = <spare>
D5 = GP59, D13 = <spare>
D4 = GP59, D12 = <spare>
D3 = GP59, D11 = <spare>
D2 = GP59, D10 = Receiver protection fault
D1 = GP59, D9 = GP outputs #7 and #8 use Hi-SNR format
D0 = GP59, D8 = Major mode refused to use external trigger
17 Immediate Status 64–70
D6 = <spare>
D5 = <spare>
D4 = <spare>
D3 = <spare>
D2 = <spare>
D1 = <spare>
D0 = GP59, D15 = <spare>
18 Latched Status 0–6
D6 = GP9, D6 = Command received while FIFO full
D5 = GP9, D5 = FIFO overflow during last PROC command
D4 = GP9, D4 = <spare>
D3 = GP9, D3 = PRT varied by more than 10 microseconds
D2 = GP9, D2 = No trigger during PROC command
D1 = GP9, D1 = Trigger too fast during noise measurement
D0 = GP9, D0 = No trigger during noise measurement
19 Latched Status 7–14
D6 = GP9, D13 = <spare>
D5 = GP9, D12 = <spare>
D4 = GP9, D11 = Measured phase sequence is invalid
D3 = GP9, D10 = Error in LSIMUL command protocol
D2 = GP9, D9 = Error in last LRMSK command
D1 = GP9, D8 = <spare>
D0 = GP9,D7 = Error detected during last SNOISE command
20 Latched Status 15–21
D6 = <spare>
D5 = <spare>
D4 = <spare>
D3 = <spare>
D2 = <spare>
D1 = GP9, D15 = Invalid processor
configuration
D0 = GP9, D14 = <spare>
RVP900 User Guide M211322EN-J
420