Char Function
21 SOPRMS Status 0–6
D6 = GP31, D6 = <spare>
D5 = GP31, D5 = 3x3 filtering enabled
D4 = GP31, D4 = <spare>
D3 = GP31, D3 = <spare>
D2 = GP31, D2 =
Reflectivity speckle remover on
D1 = GP31, D1 = Doppler speckle remover on
D0 = GP31, D0 = Reflectivity is range normalized, else SNR
22 SOPRMS Status 7–13
D6 = GP31, D13 = Polarization bit 1: 0=Horiz, 1=Vert
D5 = GP31, D12 = Polarization bit 0: 2=Alternating, 3=Dual
D4 = GP31, D11 = Disables header output
D3 = GP31, D10 = Use any spectrum size
D2 = GP31, D9 = Output is in 16-bit format
D1 = GP31, D8 = Enable clutter microsupression
D0 = GP31, D7 = Use 3-lag processing for widths
23 SOPRMS Status 14–21
D6 = <spare>
D5 = <spare>
D4 = <spare>
D3 = <spare>
D2 = <spare>
D1 = GP31, D15 = <spare>
D0 = GP31,D14 = <spare>
24 Status Bits 6 5 4 3 2 1 0
25 Status Bits 13 12 11 10 9 8 7
26 Status Bits 20 19 18 17 16 15 14
27 Status Bits 27 26 25 24 23 22 21
28 Status Bits 34 33 32 31 30 29 28
29 Status Bits 41 40 39 38 37 36 35
30 Status Bits 48 47 46 45 44 43 42
31 Status Bits 55 54 53 52 51 50 49
32 Status Bits 62 61 60 59 58 57 56
33 Status Bits 63
34-43
<spare>
44 END OF MESSAGE (FF Hex)
Appendix E – Serial Status Formats
421
To Next Page
Loading...