Vaisala RVP900 - Configuring Automatic Startup of tsimport and tsexport; Configuring Network Buffering for tsimport

• The first uncommented line of the file indicates the version of the IRIS support software
that was last used to machine–generate the file.
This is an information-only field for traceability purposes and is not edited. For
example:
# splConfig.sVersion = "7.32"
On the TTL connectors (J1, J2, J4, J5, J7), each connector must be exclusively used for
INPUT (s vars) or OUTPUT (c vars). You cannot mix these on an individual connector.
Summary of
softplane.conf Status
and Control Bits
Description
Control Output Meaning/Interpretation
cPedAZ[15:0] 16 bits of antenna azimuth angle relative to the pedestal (fixed base
system)
cPedEL[15:0] 16 bits of antenna elevation angle relative to the pedestal (fixed base
system)
cEarthAZ[15:0] 16 bits of antenna azimuth angle relative to the earth (moving
platform)
cEarthEL[15:0] 16 bits of antenna elevation angle relative to the earth (moving
platform)
cServoPwr To control servo power on
cCabinetRelay To control a relay signal
cTransmitPwr Request transmit power on
cPWidth[3:0] Request one of four pulse widths
cTrigBlank Trigger blanking signal
cRadiateOn Request radiate on
cRadiateOff Request for radiate o
cReset Request a reset of external equipment
cIrisMode[2:0] Request the application software (e.g., IRIS) to switch to 1 of 8
operating modes.
cAux[63:0] Arbitrarily assigned output requests
true Internal logic variable
false Internal logic variable
sPedAZ[15:0] 16 bits of antenna azimuth angle relative to the pedestal (fixed base
system)
sPedEL[15:0] 16 bits of antenna elevation angle relative to the pedestal (fixed base
system)
sServoPwr Servo power on indicator
Appendix F – Softplane.conf
425