Vaisala RVP900 - J2 “Filter Amp #2”; J3 “Pedestal”; J4 “Transmitter”; J5 “STC #1”

#
#
# Softplane Configuration File
#
# The following general purpose control and status signals:
#
...
# –––––––––––––––––––– RVP9IFD #0 ––––––––––––––––––––
#
# If you change the in–use flag, run ’softplane –resave’ to rev the choices.
#
splConfig.Rvp9[0].lInUse = 1
# The remote backpanel type must be one of the following:
# Common : Direct connections using the ’Common I/O’ model
# TDWR : MIT/LL TDWR custom breakout panel and protocols
# If you change this, run ’softplane –resave’ to rev the choices.
#
splConfig.Rvp9[0].sNetPanel = ”TDWR”
softplane.conf file: RCP8 example
The following shows an example from the beginning and some excerpts from the
softplane.conf
file.
To display the file on the terminal, give the command: cat.
RVP900 User Guide M211322EN-J
460