Vaisala RVP900 - J6 “STC #2”; J7 “Stability Monitor”; J8 “REX Power”

Softplane Configuration File
The following general purpose control and status signals can be routed to/from
any available hardware pin. The '~' prefix character may be used for signal
inversion.
Control Outputs Status Inputs
cPedAZ[15:0] sPedAZ[15:0]
cPedEL[15:0] sPedEL[15:0]
cEarthAZ[15:0] sServoPwr
cEarthEL[15:0] sLocal
cServoPwr sStandby
cCabinetRelay sLowerEL
cTransmitPwr sUpperEL
cPWidth[3:0] sTransmitPwr
cTrigBlank sTransmitLocal
cRadiateOn sPWidth[3:0]
cRadiateOff sTrigBlank
cReset sRadiate
cIrisMode[2:0] sAirflowFlt
cAux[80:0] sWavegpFlt
true sInterlockFlt
false sMagCurrentFlt
sReset
sIrisMode[2:0]
sAux[319:0]splConfig.sVersion = "8.00"
# ------------------- IO62 Slot #0 -------------------
#
splConfig.Io62[0].lInUse = 1
# The remote backpanel type should be one of the following:
# Direct : Direct I/O with IO62 connector itself
# IO62CP : Standard IO62-CP connector panel
# RCP88D : RCP8 portion of WSR88D panel
# RVP88D : RVP8 portion of WSR88D panel
#
splConfig.Io62[0].sExtPanel = "IO62CP"# TTL/CMOS on J1
#
splConfig.Io62[0].Opt.Cp.J1.pin01 = "sPedAZ[0]"
splConfig.Io62[0].Opt.Cp.J1.pin02 = "sPedAZ[1]"
splConfig.Io62[0].Opt.Cp.J1.pin03 = "sPedAZ[2]"
splConfig.Io62[0].Opt.Cp.J1.pin04 = "sPedAZ[3]"
splConfig.Io62[0].Opt.Cp.J1.pin05 = "sPedAZ[4]"
splConfig.Io62[0].Opt.Cp.J1.pin06 = "sPedAZ[5]"
splConfig.Io62[0].Opt.Cp.J1.pin07 = "sPedAZ[6]"
splConfig.Io62[0].Opt.Cp.J1.pin08 = "sPedAZ[7]"
splConfig.Io62[0].Opt.Cp.J1.pin09 = "sPedAZ[8]"
splConfig.Io62[0].Opt.Cp.J1.pin10 = "sPedAZ[9]"
splConfig.Io62[0].Opt.Cp.J1.pin11 = "sPedAZ[10]"
splConfig.Io62[0].Opt.Cp.J1.pin12 = "sPedAZ[11]"
splConfig.Io62[0].Opt.Cp.J1.pin13 = "sPedAZ[12]"
splConfig.Io62[0].Opt.Cp.J1.pin14 = "sPedAZ[13]"
splConfig.Io62[0].Opt.Cp.J1.pin15 = "sPedAZ[14]"
Appendix H – TDWR Customizations
461