1-48 Engine Mechanical Industrial 1.6L
Removal Procedure
1. Remove lower part of toothed belt cover – see operation
Toothed Belt Cover – Lower Part, Remove and Install.
2. Screw fastening bolt for toothed belt drive gear into crank-
shaft and move crankshaft in engine rotational direction
by 90° (dimension I) to before TDC mark.
3. Detach or disconnect all wiring harness plugs, ground
connections and hose connections from intake manifold
– see operation Intake Manifold, Remove and Install.
4. Detach wiring harness plug (1) from DIS ignition module
and expose wiring harness.
5. Detach wiring trough (2) from camshaft housing cover
and lay aside.
6. Detach engine vent hose (3) from camshaft housing and
engine vent flange and remove.
7. Remove coolant hose (6) from thermostat housing.
8. Detach ignition cable wiring trough from camshaft hous-
ing cover.
9. Disconnect spark plug connectors.
To Next Page
Loading...