WinGD X92 - Page 110

Maintenance1132−2/A1
Winterthur Gas & Diesel Ltd.
10/ 15
9) Use the manual ratchet (H1, Fig. 15) to
turn the bearing shell (3) until the
center of the bearing shell (1) is in a
vertical position.
Note: If the bearing shell (1) does not
move freely during the removal
procedure, you must attach the
lifting plate (94119A, Fig. 14) to the
other side of the dismantling tool
(94118C). You must move the
bearing shell back to its initial
position and do the removal
procedure again.
10) Remove the dismantling tool 94118C,
lifting plate 94119A and manual ratchet
(H1) from the bearing shell (1).
11) Attach the lifting device 94116A to the
bearing shell.
12) Attach the manual ratchet (H1) to the
lifting device 94116A.
13) Use the manual ratchet (H1) to lift the
bearing shell.
14) Attach eye bolt 94045-M56 to the roof
in the column, see Fig. 16.
15) Attach the chain block 94017-028 (H4)
to the to the eye bolt 94045-M56.
16) Attach hook of chain block H4 to lifting
device 94116A at bearing shell (1).
17) Take over the bearing shell (1) from
manual ratchet (H1) to chain block
(H4).
18) Attach the chain block 94017-028 (H2)
with shackle 94019P to the column.
19) Attach hook of chain block H2 to the
lifting device 94116A and take over the
bearing shell.
20) Put sling 94039-015 around the gallery
and attach chain block 94017-029 (H3)
to the sling.
21) Attach the chain block (H3) to the lifting
device 94116A.
22) Use the spur-geared chain blocks (H2)
and (H3) to move the bearing shell (1)
through the opening in the column.
23) Lower the bearing shell (1) on to a
wooden underlay.
2015
Main Bearing Removal and Installation
Fig. 15
1
94116A
Fig. 16
H1
WCH03015
1
H1
94116A
Note: Some parts can look different
H3
9
4039−015
WCH03015
H4
94116A
94045−M56
H2
1