MaintenanceTOC
4
Winterthur Gas & Diesel Ltd.
4/ 4
2017-01
Piping Group 8
Exhaust Waste Gate (Low-load Tuning) 8135−1/A1...................................................
HP Servo Oil Pipe: Removal, Grind Sealing Faces and Installation (with HAWE SOP) 8447−1/A1.........
Hydraulic Pipe − Exhaust Valve Drive: Removal, Grind Sealing Faces and Installation 8460−1/A1........
HP Injection Pipe: Removal, Grinding and Installation 8733−1/A1.....................................
HP Fuel Pipe: Removal and Installation 8752−1/A1...................................................
Crank Angle Sensor Unit, Tools Group 9
Crank Angle Sensor Unit: Proximity Sensor − Replace 9223−1/A1.....................................
Relief Valve on Cylinder Cover, Blow−off Pressure Check 9308−1/A1..................................
Tools: Explanation 9403−1/A1......................................................................
Hydraulic Pre-tensioning Jacks and Pumps
Arrangement and Application 9403−2/A1..........................................................
Storing, Servicing and Maintenance 9403−3/A1....................................................
General Instruction 9403−4/A1...................................................................
Tool List 9403−5/A1................................................................................
Standard Tools Pages 1 to 33...................................................................
Recommended Special Tools Pages 34 to 36......................................................
Winterthur Gas & Diesel Ltd.X92 / MM / 2020
To Next Page
