WinGD X92 - Page 479

Maintenance
8447−1/A1
Winterthur Gas & Diesel Ltd.
1/ 4
Removal, Grind Sealing Faces and Installation
Tools:
1 Grinding tool 94871
1. Preparation 1.......................................................
2. Removal − Servo Oil Pipes 2........................................
3. Sealing Faces − Grind 3.............................................
4. Adjustment 3.......................................................
5. Installation 4.......................................................
1. Preparation
1) Stop the engine (see the Operation Manual 4002-2).
2) Make sure that the service pump is set to off.
3) Put an oil tray under the applicable servo oil pump (1, Fig. 1).
4) Remove the stirrup bolts (2) from the applicable HP servo oil pipe.
Fig. 1
For Views I − I to
III − III see Fig. 2
and Fig. 4
II
II
III
III
DRIVING END
1
WCH02736
I
I
WCH02736
2
2
I
I
2015
HP Servo Oil Pipe