Maintenance
TOC
Winterthur Gas & Diesel Ltd.
3/ 4
2017-01
Piston
Removal and Installation 3403−1/A1..............................................................
Disassemble and Assemble 3403−3/A1...........................................................
Top Surface − Check 3403−4/A1.................................................................
Piston Rings: Wear of Piston Rings and Ring Grooves 3425−1/A1.....................................
Driving Wheels and Shut-off Valve for Starting Air Group 4
Driving Wheels
Running and Backlash Clearances and Tooth Condition 4103−1/A1..................................
Shut-off Valve for Starting Air: Cleaning and Function Check 4325−1/A1...............................
Supply Unit, Injection and Exhaust Valve Control Group 5
Servo Pump Unit
Servo Oil Pump − Removal and Installation 5551−1/A1.........................................
Supply Unit
Camshaft and Bearing Shells − Removal and Installation 5552−1/A1.................................
Camshaft and Bearing Shells − Removal and Installation (Independent Lubrication System) 5552−1/A2...
Lubrication of Fuel Pump During Maintenance Works 5552−2/A1.....................................
Fuel Pump
Disassemble, Assemble 5556−1/A1..............................................................
Removal of a Seized Pump Plunger 5556−2/A1....................................................
Fuel Pressure Control Valve: Removal and Installation 5562−1/A1.....................................
Relief Valve: Removal, Check, Installation 5562−2/A1................................................
Injection Control Unit: Removal and Installation 5564−1/A2...........................................
Fuel pump actuator − Connection to Fuel Pump 5583−1/A1...........................................
Faults in High Pressure Fuel System 5583−1/A2.....................................................
Servo Oil Rail: Exhaust Valve Control Unit: − Pilot valve : Removal and Installation 5612−1/A1..........
Scavenge Air Receiver and Auxiliary Blower Group 6
Scavenge Air Receiver − Clean and do Checks 6420-1/A1...........................................
Auxiliary Blower − Maintenance 6545-1/A1..........................................................
Scavenge Air Cooler − Removal and Installation 6606-1/A1...........................................
Scavenge Air Cooler − Cleaning Instructions 6606-1/A2..............................................
Water Separator − Removal and Installation 6708-1/A1...............................................
Cylinder Lubrication Group 7
Cylinder Lubricating System 7218−1/A1.............................................................
Winterthur Gas & Diesel Ltd. X92 / MM / 2020
To Next Page
