MaintenanceTOC
2
Winterthur Gas & Diesel Ltd.
2/ 4
2017-01
Hydraulic Engine Stays: Checking the Oil Pressure 1715−1/A2........................................
Tie Rod: Pre-tension Checks and Tie Rod Replacement 1903−1/A1....................................
Cylinder Liner and Cylinder Cover Group 2
Cylinder Liner
Measuring Bore Wear 2124−1/A1................................................................
Removal and Fitting 2124−2/A1..................................................................
Removal and Installation (with optional tool) 2124−2/A2.............................................
Removing the Wear Ridge, Re-dressing Lubricating Grooves
and Scavenge Ports 2124−3/A1.................................................................
Lubricating Quill: Removal and Installation 2138−1/A2...............................................
Piston Rod Gland: Remove, Disassemble, Measure Worn Parts, Assemble, Install 2303−1/A1...........
Cylinder Cover
Removal and Fitting of Cylinder Cover and Upper Water Guide Jacket 2708−1/A1......................
Machining of Sealing Face for Injection Valve 2708−3/A1............................................
Injection Valve: Replacement 2722−1/A1............................................................
Injection Valve:
Disassemble, Checks, Assemble (Injection Valve with FAST) 2722−2/A1.............
Starting Air Valve: Removal, Disassemble, Grinding, Assemble, Installation 2728−1/A1.................
Exhaust Valve
Exhaust Valve − Removal and Installation 2751−1/A1...............................................
Disassemble and Assemble 2751−2/A1...........................................................
Valve Seat − Replace / Grind 2751−3/A1..........................................................
Grinding the Seating Surface on the Valve Head 2751−4/A1.........................................
Crankshaft, Connecting Rod and Piston Group 3
Crankshaft: Measuring Crank Deflection 3103−1/A1..................................................
Vibration Damper
Inspection (GEISLINGER Vibration Damper) 3130−2/A1............................................
Axial Detuner: Disassembly and Assembly 3140−1/A1...............................................
Turning Gear: Teeth and Screwed Connections − Check 3206−1/A1...................................
Crankcase: Platforms 3301−1/A1...................................................................
Connecting Rod
Bottom End Bearing − Removal, Inspection and Installation 3303−2/A1...............................
Bottom End Bearing − Removal, Inspection and Installation 3303−2/A2...............................
Top End Bearing − Removal, Inspection and Installation 3303−3/A1..................................
Removal and Installation 3303−4/A1..............................................................
Top End Bearing Cover − Removal, Inspection and Installation 3303−5/A1............................
Crosshead
Crosshead Pin − Removal / Installation / Clearance Checks 3326−1/A1...............................
Crosshead Pin − Removal / Installation / Clearance Checks 3326−2/A1...............................
Winterthur Gas & Diesel Ltd.X92 / MM / 2020
To Next Page
