WinGD X92 - Page 453

Maintenance
6606−1/A1
Winterthur Gas & Diesel Ltd.
7/ 8
13) At the driving end, put a new O-ring (7, Fig. 9) in position.
14) Put the collar (5) in position.
15) Attach the flange (3) to the SAC (4) with the screws (6).
16) Tighten all the screws (6), see also tightening instruction 0352−1
17) At the free end, put a new O-ring (10) in position.
18) Put the collar (8) in position.
19) Put the flange (10) in position.
20) Attach the four clamps (9) to the SAC (1) with the screws (12).
21) Tighten the screws (12).
I
7
6
3
5
8
9
II
2
4
2
Fig. 9
10
III
WCH02970
1
2
3
4
WCH02970
FRONT OF SAC
I
III
WCH02970
II
4
8
WCH02970
9
11
REAR OF SAC
WCH02970
12
2015
Scavenge Air Cooler: Removal and Installation