WinGD X92 - Page 465

Maintenance
6708−1/A1
Winterthur Gas & Diesel Ltd.
7/ 8
3.2 Front Water Separator
1) In paragraph 3.1, do steps 1) to 8) for
the front water separator, then continue
with step 2) below.
2) Align the front and rear water
separators (1 and 4, Fig. 15).
3) Install the two top screws (3) and the
two bottom screws (2) to keep the
water separators together.
4) Operate the manual ratchet (H4) to pull
the water separators a small distance
into the receiver.
5) Remove the spur-geared chain block
(H1) from the tool (94667).
6) Remove the tool (94667) from the
water separator (4).
7) Operate the manual ratchet (H4) to pull
the water separators (1 and 4, Fig. 16)
fully into the receiver.
8) Remove the spur-geared chain blocks
(H1, H2).
9) Remove the shackles (94018A).
10) Remove the tool (94667) and the
holder (94667G).
2015
Fig. 15
Fig. 16
1
4
2
3
WCH02967
H1
H494667
4
94667G
1
WCH02967
Water Separators: Removal and Installation