February 2013
2-48
ColorQube® 9303 Family
03-401-00, 03-403-00, 03-417-00
Status Indicator RAPs
03-401-00, 03-403-00 Fax Not Detected RAP
03-401-00 The basic fax module has not been detected or confirmed.
03-403-00 Extended fax PWB has not been confirmed or detected. This is for information only.
The machine does not have an extended fax PWB.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
1. Switch off the machine, then switch on the machine, GP 14.
2. Check that the Fax module, PL 20.05 Item 1, has been installed.
3. Perform the Initial Actions in 20A Fax Entry RAP.
4. Perform the 20G Fax Module Checkout RAP.
5. If necessary, install a new Fax module, PL 20.05 Item 1.
6. If necessary, re-load the software set, GP 4 Machine Software.
7. Install new components as necessary:
• Single board controller PWB, PL 3.11 Item 13.
03-417-00 Incompatible Fax Software RAP
03-417 The fax software version supplied at power up is not compatible with the image pro-
cessing software.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Switch off the machine, then switch on the machine, GP 14.
Perform the following:
• Reload the software set, GP 4, Machine Software.
• If necessary, install a new Fax module, PL 20.05 Item 1.
To Next Page
Loading...
