February 2013
4-238
ColorQube® 9303 Family
REP 12.97-171, REP 12.98-171
Repairs/Adjustments
REP 12.97-171 Pause To Unload PWB Assembly
Parts List on PL 12.140.
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine. Refer to GP 14. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the front door, front cover and top cover, REP 12.1-171.
2. Remove the pause to unload (PTU) PWB, Figure 1.
Figure 1 Remove the PTU PWB
Replacement
Reverse the removal procedure to replace the PTU PWB.
REP 12.98-171 Inserter Idle Roller Assembly
Parts List on PL 12.310.
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine. Refer to GP 14. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the Inserter front and rear covers., REP 12.83-171.
2. Remove the inserter motor, REP 12.84-171.
3. Remove the inserter clutch, REP 12.86-171.
4. Remove the top cover assembly, REP 12.91-171.
5. Remove the inside top cover and top left door interlock switch, REP 12.88-171.
1
Disconnect the harness.
Bracket
2
Remove the pause to
unload (PTU) PWB.
To Next Page
Loading...
Need help?
General
