Xerox DocuCentre SC2020

Fax
Xerox
®
DocuCentre
®
SC2020
User Guide
121
Item Description
Sent No. The serial number of each outgoing fax.
Job# A document number appended automatically when the fax job is
received.
Remote
Terminal
The sender's information, in the following priority order:
1. Name registered in Speed Dial number2/22/16(Only when the
recipient has a registered Speed Dial number.)
2. Phone number used when all digits are dialed
3. Remote ID
4. Communication mode
The Remote ID is the phone number sent by the recipient.
Start Time The time at which transmission began.
For a fax broadcast, the time at which the first transmission started.
Dura. The amount of time that was required from transmission start to end.
For a fax broadcast, this is the total transmission time for all recipients.
Pages The number of pages sent.
The number on the left of the slash (/) is the number of pages sent
normally. The number on the right of the slash(/) is the total number of
scanned pages.
This is left empty for fax broadcasts.
Mode The mode used for the transmission.
G3, SG3, ECM, *G3, *SG3, *ECM (The asterisks indicate that the
transmitted data was converted to monochrome), or blank (no
information)
Contents The transmission content.
Resend (resent fax), Broadcast (fax broadcast), Forward (forwarded fax),
or blank (normal transmission)
Result The transmission result.
Done (normal end), Busy (recipient line was busy or the set number of
Redials was exceeded), Auto Resend (Job is set to be resent, and the
resending count is within the limit), Cancelled (job was cancelled), Conf.
Partner (the destination is unable to receive the job), Send Again (the
resending count exceeded the limit), XXX-XXX (communication error)
• "Cancelled" indicates that the user cancelled the job.
• "XXX-XXX" indicates an error code.
Total The total number of pages sent.