Maintenance
Xerox
®
DocuCentre
®
SC2020
User Guide
251
Do not use benzene, paint thinner, or other organic solvents. Doing so may damage paint or coating on
plastic parts.
Note: Cleaning the device with an excessive amount of water may cause the device to malfunction or
damage documents during copying, scanning, faxing or printing.
1. Lift the latch of the document feeder top cover until it is completely open.
Note: When you fully open the cover, it enters a fixed position. Open the cover gently.
2. While turning the rollers, wipe them with a soft cloth moistened with water.
Do not use cleaning agents other than water or neutral detergent.
Notes:
•
Use a cloth firmly wrung to prevent water drops from falling into the device. If water gets
into the device, it may cause the device to malfunction.
• If you cannot remove dirt easily, gently wipe the rollers with a soft cloth moistened with a
small amount of neutral detergent.
3. Close the document feeder top cover until it clicks into place, and confirm that there is no space
between the near or far side of the cover and the document feeder.
Managing the Device
This section describes how to check the device status using CentreWare Internet Services or the Status
Messenger feature.