Xerox DocuCentre SC2020 User Manual

Appendix
Xerox
®
DocuCentre
®
SC2020
User Guide
310
• Paper Setting
When paper jam occurs at a tray, reduce the sheets of paper in the tray.
•Management
Auditron is effective only for copy and print jobs. It does not control scan or fax jobs.
•<Data> LED
When the device has entered the Power Saver mode, the <Data> LED is extinguished even when a
received or pending fax job remains in the device. The <Data> LED does not light up in the Power
Saver mode even when the device receives a print job.
• Image Quality
• When the default for [Output Color] is set to [Black & White], the color density of the first color output
image after the device is turned on may be slightly deteriorated. Use the automatic calibration
function.
• Right after the drum cartridge or toner cartridge is replaced, the image quality may be poor. Also, if
the toner level is low, the output image quality may be poor.
Notes and Restrictions on the Use of the Copy Feature
•ID Card Copy
The front and back side of the placed ID card are printed on each half sheet of a paper in center
except the following cases:
• When the size of ID card is larger than the standard printable size of the ID Card Copy feature, a part
of the image may be cut off.
• The edges of the ID card may be cut off due to the edge erase.
•About Memory
If the device memory capacity becomes insufficient when copying using the collated feature, it
outputs only the document data which is being scanned.
• Image quality
This device reads documents using a CIS sensor. There are some pixels that cannot be read by the CIS
sensor for structural reasons. In the following documents, the lines in the vertical direction may appear
spaced about 18 mm apart.
• Documents with uniform concentration
• Documents with gradation
• Documents with fine lines that repeat periodically
In this case, either [Soften] the sharpness or set the image quality of the document to [Photo] and
then adjust the image quality.
Notes and Restrictions on the Use of the Scan Feature
This section describes notes and restrictions to observe when using the Scan feature.
For the notes and restrictions on the scan driver, see the "Readme" information on the CD-ROM for the
Driver CD Kit that came with the device.
• Address Book

Xerox DocuCentre SC2020 Specifications

General

Print technology	Laser
Maximum resolution	1200 x 2400 DPI
Booklet printing function	Yes
Time to first page (black, normal)	12 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Time to first copy (black, normal)	8.6 s
Time to first copy (color, normal)	10.8 s
Scan to	PC, TWAIN
Scanner type	-
Scan speed (black)	24 ppm
Scan speed (color)	19 ppm
Image formats supported	JPEG, TIFF
Document formats supported	PDF
Optical scanning resolution	600 x 600 DPI
Product color	Blue, White
Display diagonal	4.3 \
Market positioning	Business
Wi-Fi	No
Cabling technology	10/100Base-T(X)
Ethernet LAN data rates	10, 100 Mbit/s
Maximum duty cycle	- pages per month
Number of print cartridges	4
Page description languages	PCL 5e, PCL 6
Fax coding methods	JBIG, MH, MMR (Fax coding method), MR
ISO A-series sizes (A0...A9)	A3, A4, A5
Maximum ISO A-series paper size	A3
Total input capacity	350 sheets
Total output capacity	250 sheets
Maximum input capacity	850 sheets
Internal memory	512 MB
Power consumption (average operating)	1200 W
Server operating systems supported	Windows Server 2003, Windows Server 2008, Windows Server 2012
Windows operating systems supported	Windows 7, Windows 8.1, Windows Vista, Windows XP

Weight and Dimensions

Depth	586 mm
Width	595 mm
Height	634 mm