Xerox DocuCentre SC2020

Tools
Xerox
®
DocuCentre
®
SC2020
User Guide
161
Network Setup
Use the [Network Setup] menu to change the device settings affecting jobs sent to the device through the
network.
Note: Bold values are the factory default menu settings.
Ethernet
Purpose: To confirm or specify network settings.
IP Mode
Purpose: To configure the IP mode.
Values:
TCP/IP
Purpose: To configure TCP/IP settings.
Values:
Dual Stack Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv6 Mode Uses IPv6 to set the IP address.
Get IP Address DHCP/AutoIP Sets the IP address automatically. A random value in the
range of "169.254.1.0" to "169.254.254.255" that is not
currently in use on the network is set as the IP address.
The subnet mask is set as "255.255.0.0".
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP address
manually on the control panel.
IP Address When an IP address is being set manually, the IP is
allocated to the device using the format
"nnn.nnn.nnn.nnn". Each octet that makes up
"nnn.nnn.nnn.nnn" is a value in the range of "0" to "254".
"127" and any value in the range of "224" to "254" cannot
be specified for the first octet of a gateway address.