Xerox DocuCentre SC2020

Tools
Xerox
®
DocuCentre
®
SC2020
User Guide
162
IPsec
Note: IPsec feature is available only when IPsec is enabled on CentreWare Internet Services.
Purpose: Disables IPsec.
Value:
Connection Speed
Note: Connection Speed feature is available only when the device is connected using the network.
Purpose: To specify the communication speed and the duplex settings of Ethernet. The change becomes
effective after the device is turned off and then on again.
Values:
Protocols
Purpose: To enable or disable each protocol. The change becomes effective after the device is turned off
and then on again.
Subnet Mask When an IP address is being set manually, the subnet
mask is specified using the format "nnn.nnn.nnn.nnn".
Each octet that makes up "nnn.nnn.nnn.nnn" is a value in
the range of "0" to "255". "255.255.255.255" cannot be
specified as the subnet mask.
Gateway Address When an IP address is being set manually, the gateway
address is specified using the format "nnn.nnn.nnn.nnn".
Each octet that makes up "nnn.nnn.nnn.nnn" is a value in
the range of "0" to "254. "127" and any value in the range
of "224" to "254" cannot be specified for the first octet of
a gateway address.
Disable Disables IPsec.
Auto Detects the Ethernet settings automatically.
10BASE-T Half Uses 10BASE-T Half-duplex.
10BASE-T Full Uses 10BASE-T Full-duplex.
100BASE-TX Half Uses 100BASE-TX Half-duplex.
100BASE-TX Full Uses 100BASE-TX Full-duplex.