Tools
Xerox
®
DocuCentre
®
SC2020
User Guide
164
Services.
Advanced Settings
Purpose: To specify advanced network settings.
IP Filter
Note: IP Filter feature is available only when [Protocols] is set to [LPD] or [Port9100].
Purpose: To block data received from certain IP addresses through the network. You can set up to five IP
addresses. The change becomes effective after the device is turned off and then on again.
Values:
802.1x
Note: 802.1x feature is available only when the device is connected using LAN cable and the 802.1x
authentication is enabled using CentreWare Internet Services. For information on setting 802.1x, refer
to the online Help of the CentreWare Internet Services.
Purpose: To disable 802.1x authentication. The change becomes effective after the device is turned off and
then on again.
Values:
Reset Network Setup
Purpose: To initialize network data stored in non-volatile memory (NVM). After executing this function and
rebooting the device, all network settings are reset to their default values.
Values:
Delete All Certificates
n (n is 1–5) IP Address Sets the IP address for Filter n.
Subnet Mask Sets the address mask for Filter n.
Mode Not Active Disables the IP Filter feature for Filter
n.
Accept Accepts an access from the specified
IP address.
Reject Rejects an access from the specified
IP address.
Disable Disables 802.1x.
Reset Initializes the network data stored in NVM.