Xerox DocuCentre SC2020

Tools
Xerox
®
DocuCentre
®
SC2020
User Guide
217
5. Select [Panel Lock].
6. Select [Panel Lock Set].
7. Select [Enable], and then select [OK].
8. Enter the new passcode, and then select [OK].
Note: The factory-default panel passcode is 0000.
– Be sure to remember the passcode. The procedure described below allows you to reset the
passcode, but the settings for Address Book are cleared.
– Turn off the device. Then, while holding the <Machine Status> button, turn on the device.
– If you change the passcode while [Panel Lock Set] is [Enable], perform steps 1 to 3. Enter the
current passcode, and then select [OK]. Perform steps 4 and 5. Select [Change Passcode], and
then select [OK]. Enter the current passcode, and then select [OK]. Perform steps 8 and 9. This will
change the passcode.