6-26 Phaser 6121MFP Service Manual
Adjustments and Calibrations
Temperature
Function
Adjusts the fusing heating temperature for each paper type so as to ensure good
fusing performance that varies with varying environmental conditions.
Use
When fusing performance is poor, or wax streak or offset occurs when the type of
paper is changed or environmental conditions change.
Use this function when using curled paper, or paper misfeed as a result of the
curled paper occurs. Curling occurs under varying environmental conditions or
depending on the type of paper used.
Default Setting
The default setting is 0° C.
Adjustment Range
-10° C, -5° C, and 0° C.
Procedure
1. Select Temp e rat ure and press the OK button.
2. Select the type of paper and press the OK button.
3. Select desired setting value with the Up and Down Arrow buttons, and then
press the OK button.
Adjustment Instructions
If fusing performance is poor, increase the setting.
If wax streaks occur, decrease the setting.
If offset is poor, decrease the setting.
If curling of the paper occurs, decrease the setting.
To Next Page
Loading...
