6-12 Phaser 6121MFP Service Manual
Adjustments and Calibrations
Protocol Report
The Protocol Report provides transmission results, timing, and communications
activity information about each Fax transmission.
Default Setting
The default setting is Off.
Available Settings
• Off: Disable the T.30 communication report.
• On: Print a T.30 communication report after every Fax transmission.
• On Error: Print a T.30 communication report only when an error occurs.
GDI Time-out
Specifies the time for GDI time out.
Default Setting
The default setting is 60 seconds.
Available Settings
•5 Sec
•10 Sec
•20 Sec
•30 Sec
•40 Sec
•50 Sec
•60 Sec
To Next Page
Loading...
