Phaser 6121MFP Service Manual A-7
Reference
Copy Menu
This section contains:
• “Copy Menu – Main” on page A-7
• “Copy Default Setup Menu” on page A-8
To access the Copy Menu, press the Copy button on the control panel.
Copy Menu – Main
Menu Item Contents
Paper Source Specifies the tray to use and the type and size of the
paper in the tray when making copies.
Scale Specifies the image size of the copy in comparison to
the original:
■ Manual – Enter the desired size.
■ Preset Sizes – Select from a list of preset sizes.
Lighten/Darken Specifies how light or dark the resulting copied image
is (also called “copy density”).
Original Document
Type
Specifies the type of content being copied:
■ Mixed, Fine/Mixed – Text with images/photos.
■ Photo, Fine/Photo – Photos only.
■ Text, Fine/Text – Text only.
Sides (Duplex)
(Phaser 6121MFP/D
printer configuration
only)
Specifies the setting for double-sided copying:
■ 1 to 1 – Copying on one side only.
■ 1 to 2 – Copying on two sides:
Long Edge Flip – Copied pages are printed so
that they flip over at the side, along the long edge
of the paper.
Short Edge Flip – Copied pages are printed so
that they flip over at the top, along the short
edge of the paper.
Collate
(Phaser 6121MFP/N
and /D printer
configurations only)
Specifies whether the copied pages of multi-page
documents are printed in order and sorted by copy
set.
2-Up Copy
(Phaser 6121MFP/D
printer configuration
only)
When selected, two single-sided document pages are
copied and then printed onto one side of a single
sheet of paper. The copies are reduced to fit on the
size of the selected output page.
Special Copy Mode
■ ID Copy – Used for copying ID cards. The back and
front of a document are copied at full size onto one
side of a single sheet of paper
■ None (Normal Copy)
■ Poster Copy – The length and width of the copied
document are each enlarged 200% and are printed
on four pages.
■ Clone Copy – Repeat copying; used to copy small
documents onto one piece of larger paper.
To Next Page
Loading...
