A-6 Phaser 6121MFP Service Manual
Reference
General Setup Menu
The General Setup Menu is a sub menu of the System Menu.
Menu/Item Contents
Front Panel
Timeout
Controls the length of time before the printer
automatically returns to the default menu display when
there has been no activity at the control panel:
■ Off – Menu does not return to the default after a
specific period of no activity.
■ 30 Sec, 1 Min, (etc.) – After the selected period of time
with no activity at the control panel, the control panel
returns to its default menu.
Power Saver Mode Determines the length of time the printer sits idle before
it goes into sleep mode.
LCD Contrast Controls the brightness of the LCD panel.
Key Repeat Setup Controls key repeat delay used when pressing a key to
input one of the letters associated with that key button
on the alphanumeric keypad.
Cursor Movement
(Phaser 6121MFP/N
or /D only)
Controls the time the cursor takes to move to the next
menu item column.
Display Language Language used by the printer to display and print
information.
Speaker Volume
(Phaser 6121MFP/N
or /D only)
Controls the volume of the key touch and alert sounds.
Initial Mode Controls which is the default printer mode:
■ Copy
■ Scan
■ Fax (Phaser 6121MFP/N or /D only)
Toner Out A ction Controls the action when a toner cartridge is out of toner:
■ Stop All – Stops all printing.
■ Continue – Continue printing.
Toner Low Prompt When enabled, the system displays a “Toner Low”
message when the toner is low.
Size Mismatch? Controls the action when a size difference exists between
the original and the paper in the tray:
■ Continue Print
■ Request Paper Size
Image Refresh Use when faint lines occur at a pitch of 24 mm in the
main scanning direction?
If one image refresh sequence does not make the faint
lines less noticeable, run it a second time.
Duplex Speed
(Phaser 6121MFP/N
or /D printer
configurations only)
Controls speed of 2-sided printing and copying functions.
Calibrate Now? Calibrates the color curve once.
Reset to Default? Resets all of the above settings to their factory defaults.
To Next Page
Loading...
