Xerox Phaser 8500 Service Manual

Phaser 8400/8500/8550/8560 Color Printer Service Manual 5-43
Print-Quality Troubleshooting
Manuf. Skew Margins
This print consists of an image used by manufacturing to gauge skew and
margin on 2
sided prints.
To measure skew, measure between the edge of the paper and the magenta
frame should be within tolerance along the entire length of the top of the
paper. For example, the measurement on the top left side of the sheet should
be the same as the measurement on the top right side of the sheet (within
tolerance).
To calculate skew, measure the margin at the leading edge of each corner,
then take the difference between them. For example, if the margin at the right
leading edge corner is 5.1
mm, and the margin at the left leading edge corner
is 4.9
mm, then the skew is (5.1 - 4.9) = 0.2 mm. Skew tolerances are:
■ All sizes except envelopes and custom sizes: 0.0 +/- 0.89 mm
■ Envelopes: 0.0 +/- 1.04 mm
■ Custom media: evaluate with the following formula: Skew Spec (mm) =
998.4*(width-12.5)^(-1.02), where width is in millimeters.
To measure margin, measure from the magenta frame to the edge of the
paper at the midpoint on the top and left-edge margin (right side of paper, left
side of printer). Margin tolerance is the margin +/- 2. See the Media Margin
Specification in the Appendix.
N
o
t
e
Measurements for skew and margin for Sides 1 and 2 may not match
Check: The media must be supported for the tray. The side and rear guides
must be adjusted to the size of the paper to ensure correct deskewing.
If you have skew on simplex prints in Trays 2, 3, or 4, check for a worn take
away roller or pick roller; in Tray 1, check for a worn pick roller. This test print
uses the tray selected in Paper Source on the Paper Handling Menu.
s8400-145
1 2 3
MM
s8400-201
1 2 3
MM
1 2 3
MM

Xerox Phaser 8500 Specifications

General

Brand	Xerox
Model	Phaser 8500
Category	Printer
Language	English