Xerox Phaser 8500 - Electronics; Electronics Module (PL5.0.5)

8-46 Phaser 8400/8500/8550/8560 Color Printer Service Manual
Service Parts Disassembly
Electronics
Electronics Module (PL5.0.5)
Caution
Touch the back of the Electronics Module before starting this procedure to
discharge any electrostatic charge present on the case. Also, do not
completely remove EMI tape, if added to a connector.
N
o
t
e
Do not fully remove EMI tape, if included with any connector.
1. Disconnect the Power Cord and all connections to the Electronics
Module.
2. Remove the Ink Loader (page 8-7).
3. Remove 5 screws from the back of the Electronics Module and two
screws from inside the chassis.
4. Remove the Electronics Module.
R
ep
l
acemen
t
N
o
t
e
When replacing the Electronics Module, transfer the Configuration
Card, NVRAM (page 8-50), SODIMM RAM (page 8-51), and Hard
Drive (page 8-52, if installed) to the new module.
s8500-110
EMI Tape (8500/8550/8560)