• Transfer defects may occur when paper speed is too fast or too slow.
3. Change the Adjust Fusing Speed setting.
• This feature can be used to correct the issue of a smear at 208 mm from the Lead Edge (LE).
Increase the fuser speed to correct the issue.
• This feature also impacts print quality.
– Increasing fuser speed extends the image. If fuser speed is set too high, paper jams can
occur.
– Decreasing fuser speed shrinks the image.
• The option can be found in Machine Status→Tools→Setup & Adjustment→Custom Paper
Settings. Select the desired Custom Paper→Change Settings→Adjust Fusing
Speed→Change Settings.
• Increase fuser speed in increments of 0.5%. After every increment adjustment run test prints
and evaluate the output to determine if additional adjustment is necessary.
TTrraaiill EEddggee DDeelleettiioonnss
Problem
The printed output contains trail edge deletions.
Solutions
Change the Adjust Image Transfer for Trail Edge setting.
• This feature is used to adjust the voltage ratio on the Secondary Bias Transfer Roll (BTR), where
the image is transferred from the belt to the paper.
• This feature can be found in Machine Status→Tools→Setup & Adjustment→Custom Paper
Settings. Select the desired Custom Paper→Change Settings→Adjust Image Transfer for Trail
Edge→Change Settings.
• Decrease the Adjust Image Transfer for Trail Edge in increments of 5%–10%. After every
increment adjustment run test prints and evaluate the output to determine if additional
adjustment is necessary.
CCuussttoomm PPaappeerr SSeettttiinnggss -- DDeeffaauulltt SSeettttiinnggss
The information provides the default values, ranges, and recommended incremental adjustments for
the various Custom Paper Settings features, options, and settings.
261
To Next Page
Loading...
