Xerox Versant 280 Press - Streaks or Lines on Prints

Solutions
Acquire the measuring tool either from www.xerox.com/VERSANT_280docs or the Nationalization Kit.
Check the frequency of the defect interval.
• If the defect occurs every 44 mm on the prints, do not replace the drum. This interval is caused by
a damaged or defective developer housing. For more details, contact the Customer Support
Center.
• If spots or bands occur every 147 mm on the prints, a drum is damaged or light shocked. Replace
or swap the appropriate drum cartridge; refer to Replacing a Drum Cartridge.
• If the defect occurs every 374 mm on the prints, replace the fuser belt assembly. For details,
contact the Customer Support Center.
SSttrreeaakkss oorr LLiinneess oonn PPrriinnttss
Problem
The prints show solid color streaks or lines running from Lead Edge to Trail Edge (LE or TE) of prints.
244