Xerox Versant 280 Press - Printing Saddle-stitched Booklets with Full Bleed, Trimmed Edges, and Inserting Preprinted Covers; Creating Booklets with Full Bleed with the EX Print Servers

f. On the Media tab, set Paper source to Tray 5 (bypass).
g. On the Finishing tab, for Delivery options, select the Offset Catch Tray or specific Top Tray
that you want to use to collect the prints. Specify delivery of the output to the Offset Catch
Tray or a Top Tray.
7. Click Print, then monitor the printing.
PPrriinnttiinngg SSaaddddllee--ssttiittcchheedd BBooookklleettss wwiitthh FFuullll BBlleeeedd,, TTrriimmmmeedd EEddggeess,,
aanndd IInnsseerrttiinngg PPrreepprriinntteedd CCoovveerrss
Important: The following print job workflows require you to have an Inserter device, a
Production Ready Booklet Maker Finisher, a Crease and 2-Sided Trimmer, and a SquareFold
Trimmer.
This workflow produces an appealing look on the printed output because:
• The booklet maker creates saddle-stitched booklets
• The two trimmers cut off the edges on three sides of the booklets so that the images extend to
the edge of the pages
• Preprinted cover pages are inserted into the workflow with the Inserter device
There is one workflow scenario for the Xerox
®
EX 280 and EX-i 280 Print Servers, Powered by Fiery
®
.
Creating Booklets with Full Bleed with the EX Print Servers
This procedure requires the following finishing devices:
• A Production Ready Booklet Maker Finisher
• A Crease and Two-Sided Trimmer device
• Inserter device
• SquareFold
®
Trimmer device
The booklet maker creates saddle-stitched booklets, while the two trimmers cut the edges off three
sides of the booklets so that the images extend to the edge of the pages. With the Inserter device,
you can insert preprinted cover pages in this workflow. This full-bleed output produces an appealing
look for some documents.
The setup for this type of workflow includes:
• Loading the paper and programming it at the press UI
• Submitting the job and opening Job Properties
• Setting Properties for the media, layout, folding and trimming
• Selecting the settings to insert preprinted covers
• Releasing the job for a Proof copy
• Checking the output and making any adjustments to the trim settings or imposition
177