Note: The OHCF comes equipped from manufacturing with the Postcard bracket tray inserter.
If using the optional Postcard bracket, minimum size is 101.6 x 152.4 mm (4 x 6 in.)
Note: For more information on the optional Postcard Bracket, refer to Paper and Media.
Paper and Media for Trays 8 and 9
Loading Paper in Trays 8 and 9
1. Select the appropriate paper stock for your print/copy job.
2. Pull out the tray slowly until it stops.
3. Open the ream of paper with the seam side facing up.
4. Fan the sheets before loading them into the tray.
5. Load paper into the tray.
6. Adjust the paper guides by pressing in the guide release and carefully moving the Edge Guide
until it lightly touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
7. Gently push in the tray until it comes to a stop.
The Paper Tray settings/Tray Properties window displays on the UI. You can view and set stock
attributes and verify trays are assigned with the correct stock.
8. From the Paper Tray settings/Tray Properties window, enter or verify the correct paper
information, including size, type, weight and, if necessary, paper curl and/or alignment option.
Select the stock and assign the stock to the tray to be used.
9. Select Confirm or OK to save the information and close the Paper Tray settings/Tray Properties
window.
125
To Next Page
Loading...
