– If the image is shrunk, increase the fuser speed. If the fuser speed is set too high, it may
cause paper jams.
– If the image is stretched, decrease the fuser speed.
• This feature is accessed from Machine Status→Tools→Setup & Adjustment→Custom Paper
Settings. Select the desired Custom Paper→Change Settings→Adjust Fuser Speed→Change
Settings.
• Increase or decrease the fuser speed in increments of 0.1%.
• After each incremental adjustment, run test prints and evaluate the output to determine if
additional adjustments are required.
UUnnffuusseedd DDrryy IInnkk oorr TToonneerr oonn OOuuttppuutt
Problem
The output contains unfused dry ink or toner.
Solutions
1. Change the Adjust Fuser Temperature setting.
Tip: Changing the default setting of 0 (zero) is a temporary solution because
environmental conditions vary from day to day. Upon completion of the print job, the
recommendation is to return the option to its default setting.
• Use this feature to adjust the fuser temperature.
• If dry ink/toner comes off the paper, especially with special media, resolve the problem by
increasing the fusing temperature.
• If the fuser temperature is too high when printing on lightweight paper, it may cause blocking,
media damage, or paper jams at the peeling unit in the fusing module.
• If the fuser temperature is too low, it may cause poor fusing on higher-density image areas
and dry ink/toner may peel off the printed output.
• This feature is accessed from Machine Status→Tools→Setup & Adjustment→Custom Paper
Settings. Select the desired Custom Paper→Change Settings→Adjust Fuser
Temperature→Change Settings.
• Based on the printed output, increase or decrease the Adjust Fuser Temperature in
increments of 1° or 2°.
258
To Next Page
Loading...
