Use the Inserter device to load stock, such blank, preprinted, or special stock, which is inserted into
the finished output. This stock serves as separators and covers for the finished output. Paper fed from
the Inserter device is not printed on; however, the paper is placed into the printed output at selected
locations.
Note: The Inserter device sometimes is referred to as the post-process inserter or the
interposer.
Inserter Components
1. Tray T1 or Inserter Tray
2. Inserter Control Panel
3. Inserter Front Cover
Inserter Control Panel
140
To Next Page
Loading...
