Xerox Versant 280 Press - Press Does Not Power On; Cannot Obtain the Press Serial Number from the Machine Status Screen; User Interface Is Not Working

PPrreessss DDooeess NNoott PPoowweerr OOnn
Problem
The press does not power on.
Solutions
1. Ensure the power cord from the press is plugged into the power outlet or receptacle. If the
problem persists, perform the following steps:
a. From inside the front door, press off the main power switch.
b. Firmly plug in the power cord.
c. Press the power switch on.
2. From inside the front door, ensure the power switch is set to the ON position, the press the power
button ON.
Note: The power button is located on top of the press near the user interface (UI).
3. Ensure the power supply is 200–240V (volts) and 30A (amperes).
4. Ensure that the supplied power capacity is compatible with the specified maximum power
consumption of the press which is 2.8–3.1 kVA (kilo-volt-ampere).
5. Check the ground fault interrupter (GFI) circuit breakers.
6. If the power in your location is working properly and you have tried the suggested solutions, but
the press does not power on, contact the Customer Support Center for assistance.
CCaannnnoott OObbttaaiinn tthhee PPrreessss SSeerriiaall NNuummbbeerr ffrroomm tthhee MMaacchhiinnee SSttaattuuss
SSccrreeeenn
Problem
There is no power to the press, and you cannot access the Machine Status screen to get the press
serial number.
Solutions
Open paper tray 1. On the left frame, near tray 1, locate the serial number. Refer to Locating the Press
Serial Number.
UUsseerr IInntteerrffaaccee IIss NNoott WWoorrkkiinngg
Problem
The user interface (UI) is not working. It is locked up or completely dark.
230