b. Select the Tools tab.
c. Select System Settings→Common Service Settings→Maintenance.
d. Use the arrow buttons to access the next Maintenance screens.
e. Select the Technical Key Operator icon.
The Technical Key Operator feature displays.
f. Log in to the Technical Key Operator mode.
Attention
If you cannot log in as TKO, or do not have the TKO password, call your Customer Service
Engineer.
g. Select the item (HCF) that corresponds with the newly-replaced components.
h. Select Reset Current Value. The system resets the HFSI to 0.
14. Exit administrator mode by pressing the Log In/Out button on the UI.
When prompted, select Logout.
TTrraayyss 88 aanndd 99 MMaaiinntteennaannccee
Replacing Tray 5 Feed Rolls
Use this procedure by Tray 5 is installed on top of Trays 8 and 9.
Tip: The feed rolls for Tray 5 (Bypass) should be replaced when experiencing frequent
multifeeds, single feeds, or blank prints in the stack of the output prints.
Use this procedure to replace the following feed rolls for Tray 5:
• Feed Roll
• Nudger Roll
• Separator Roll
Note: After you replace all of the feed rolls, contact your system administrator who will reset
the High Frequency Service Item (HFSI) usage counter for these CRU components to zero (0).
1. Locate and access Tray 5 (Bypass) on top of Trays 8 and 9.
2. Lift up and open the Bypass Tray cover to access the feed roll components.
206
To Next Page
Loading...
