Solutions
• Ensure that the media used is approved, within press specifications and is clean.
• Check that the press is within environmental specifications and humidity levels.
• Load a new ream of paper or different type of media.
• Run the Clean Toner procedure. For instructions, refer to the the System Administrator Guide,
Maintenance→Common Service Settings.
• Check for Drum failure or damage. Acquire your measuring tool from either www.xerox.com/
VERSANT_280docs or the Nationalization Kit.
– Check the frequency of the spot intervals. If spots occur every 147 mm on the prints,
determine which color drum is affected.
– To determine which color drum is affected, go to www.xerox.com/VERSANT_280docs, to
download, and then print the Halftone Test Pattern PDF.
• To replace or swap the drum; refer to Drum Cartridge.
RReeppeeaattiinngg DDeeffeeccttss aatt RReegguullaarr IInntteerrvvaallss oonn PPrriinnttss
Problem
The prints show any defect type that repeats at intervals that can be measured.
243
To Next Page
Loading...
