Solutions
• If the UI buttons or keyboard do not work, press the power button Off. Wait 30 seconds, then
reboot the system by pressing the power button On.
• If the Power Saver button light is on, the press is in the Power Saver Mode. To cancel the Power
Saver mode, press the Power Saver button.
PPrreessss DDooeess NNoott CCoommpplleettee aa PPrriinntt JJoobb
Problem
The press does not successfully complete a print job.
Solutions
• To verify that your press connected to the network, from the print server, print a test page.
• Verify that the power cable is connected to the press and to a suitable power outlet.
• Verify that the network cables are attached securely to the press and seated properly.
• Clear out the print job from the print queue, and resend the print job.
• To restart the press, power off the press, then power it on.
• Your press may not be configured on the network. To connect the press to the network, contact
the system administrator.
TTiimmee IInntteerrvvaall BBeettwweeeenn PPrriinntt JJoobbss IIss LLoonnggeerr TThhaann 11 MMiinnuuttee
Problem
The press is taking longer than one minute before printing the next job.
Solutions
The system requires approximately 2 minutes when switching print modes in order to make any
necessary adjustments for the next print job, including color-to-color registration, density, charge
levels, bias levels, or other adjustments.
• The system has two print modes selectable at the print server:
– 4 Color Mode (CMYK: Cyan, Magenta, Yellow, Black)
– Black and White Mode Only
• If the next print job is switching print modes, for example from black-only to 4-color, the system
requires approximately 2 minutes to make any necessary adjustments.
• During this time, the touch screen displays the Adjusting Image Quality message.
• The next job begins printing once the system completes its adjustments.
Other information to remember includes:
231
To Next Page
Loading...
