Note: If you have an Inserter configured with your press, you can optionally insert pre-
printed cover sheets for the booklets. The size of the cover sheets should be the same as
the body sheets. The Booklet Maker will wrap the pre-printed cover sheet around the body
pages to form a front and a back cover.
17. For optionally inserting covers when the job is not pre-imposed:
a. Load the pre-printed cover stock into the Inserter Tray T1.
b. Program the stock at the Control Panel.
c. Select the Layout tab.
d. Select the Booklet radio button.
e. Scroll down to the Cover area.
f. For Content input, select Pre-Printed.
g. Click Define Cover.
h. For Cover source select T1.
i. For Media Weight, select the g/m
2
for the cover stock and set any other unique cover stock
properties.
j. Click OK.
k. Click Print on the Layout tab to release the job.
Note: If you have an Inserter device with your press, you can optionally insert preprinted
cover sheets for the booklets. The size of the cover sheets should be the same as the body
sheets. The Booklet Maker will wrap the preprinted cover sheet around the body pages to
form a front and a back cover.
AAddjjuussttiinngg BBooookklleett FFoolldd aanndd SSttaappllee PPoossiittiioonnss
Use this procedure:
• To adjust the staple position horizontally on the paper
• To ensure that the booklet staples lay precisely on the fold, not off the fold
Note: This procedure does not enable you to move the staples up or down on the fold. A
Customer Service Engineer must make vertical adjustments for staple positions on the fold.
To adjust the fold and staple positions for booklets, log in as Administrator and use the Tools menu.
Create a profile for a specific size booklet in terms of the number of sheets or create a profile for
booklets that vary in length.
If printing booklets that use the same number of sheets, enter that number. If printing booklets that
differ in the number of sheets used, perform adjustments separately for a small set of sheets (Set 1)
and again for a large set of sheets (Set 2). The system calculates and automatically uses the required
adjustments for booklets that vary in size between Set 1 and Set 2.
The paper weight for the booklet media is important when creating the profile. The number of sheets
used in the sets vary based on the selected weight. The system automatically determines the size of
the sets based on the selected paper weight.
179
To Next Page
Loading...
