Xerox Versant 80 Press - Fault Codes - GBC Advancedpunch Pro; Fault Codes - High Capacity Stacker (HCS)

RemedyCauseFault Code
Empty punch container and then reinstall
it.
Punch container is near full.140-700
Fault Codes - GBC AdvancedPunch Pro
Fault codes for the GBC AdvancedPunch Pro are displayed on the press User Interface
/ Control Panel.
RemedyCauseFault Code
1. Open AdvancedPunch Pro front
door and look for a paper jam; refer
to Clearing Paper Jams in the Ad-
vancedPunch Pro.
2. Remove any paper jam.
3. Close front door.
Jam is detected in the Advanced-
Punch Pro.
040-100
040-101
040-900
040-901
Close front door of the AdvancedPunch Pro.Front door of the Advanced-
Punch Pro is not closed.
040-300
Install punch die set or fully insert it; close
front door.
The punch die set is missing or
not fully installed.
040-940
Install and / or fully insert punch container;
close front door.
Punch chip container is missing
or not fully installed.
040-941
Empty punch container and then reinstall
it.
Punch chip container is full.040-942
Empty punch container and then reinstall
it.
Punch chip container is near full.140-700
Fault Codes - High Capacity Stacker (HCS)
Note
The press configuration can be installed with one or two stacker modules. If the press
includes two HCS modules, the prefix 049 identifies a fault in the first module, and the
prefix 149 identifies a fault in the second module.
This fault code table lists problems and suggested solutions that apply to the High
Capacity Stacker (HCS).
Xerox
®
Versant
®
80 Press14-28
User Guide
Press Problem Solving