Xerox Versant 80 Press - OHCF Problem Solving (Trays 6 and 7); Fault Codes - Oversized High Capacity Feeder (Trays 6 and; or 7)

f) Select the item (HCF) that corresponds with the newly-replaced components.
g) Select Reset Current Value. The system resets the HFSI to 0.
14. Exit administrator mode by pressing the Log In/Out button on the UI.
When prompted, select Logout.
OHCF Problem Solving (Trays 6 and 7)
Fault Codes - Oversized High Capacity Feeder (Trays 6 and / or 7)
The OHCF fault codes below may pertain to a specific tray of the feeder. If you experience
these fault codes frequently, you should follow the procedure on how to replace the
feed rolls (Replacing the OHCF Bypass Tray Feed Rolls (Trays 6 and 7) and Replacing
the OHCF Feed Rolls (Trays 6 and 7)).
Recommended SolutionPossible CauseFault CodeFault Area
1. Fan the paper to eliminate
paper adhesion (especially
in high humidity or high
temperature environments).
2. Clean the Bypass Tray feed,
retard, and nudger rolls with
a damp cloth.
3. Replace feed rolls (feed, re-
tard, nudger); refer to Repla-
cing the OHCF Bypass Tray
Feed Rolls (Trays 6 and 7).
4. If problem persists, Call for
service.
Repetitive misfeeds or
multifeeds
078-105,
078-120,
078-125,
078-126,
078-127
Bypass (Tray 5)
Perform the following in this order:
1. Remove or clear any
jammed paper.
2. Replace and fan the paper
in tray.
3. Power Off / On the press.
4. If problem still persists,
contact the Customer Sup-
port Center.
Pre-registration sensor jam
during paper transporta-
tion from Bypass Tray
078-110Bypass Tray
Regi sensor not turned on
fault during paper trans-
portation from Bypass
Tray
078-111Bypass Tray
Xerox
®
Versant
®
80 Press17-6
User Guide
1- or 2-Tray Oversized High Capacity Feeder (OHCF / Trays 6 and 7)